One of the most ubiquitous pieces of Playfield hardware is the Bumper.
It has at times gone by the name “Thumper”, “Jet” or “Pop Bumper”, but when people say “Bumper” they are generally referring to the switch-and- coil-activated mechanical Bumper that is standard to most modern games. At one time these Bumpers were passive, with just a rubber ring and a switch to add to the score, hence the need to have names to distinguish active Bumpers. But by the time of Pinball’s peak in the mid-80’s, most all Bumpers were active, except for a few notable games like “Silverball Mania” or “Space Invaders”.
Most machines typically have three Bumpers, but almost any combination of number or location you can think of has probably been tried. This is where the grammar and language of Pinball comes in…
If you are unfamiliar with all the Bumper variations that have been used it the past, check out the Internet Pinball Database (IPDB), and the reproductions section of the Visual Pinball (VP) website. When you design your game, you should be aware of what other games have used similar layouts. Even if you are not trying to emulate or reference vintage tables, there will always be some comparison and connotation associated with them. It’s important to understand this grammar so as to not create some unintended meaning.
The “standard” Bumper has undergone some evolution to make things easier for manufacturing, assembly and repair, even though the basic components remain the same. Here are representative examples:
- Evolution #1 : Added Nutplate: The earliest improvement was to add a plate with pre-tapped holes.
- Evolution #2 : Combined Plate and Switch: The second improvement was a plate with built-in mount for a spoon switch. This unit could be built as a sub-assembly prior to installation.
- Evolution #3 : Molded Plastic : An incremental improvement to number #2, this was probably a cost savings, but also presented a cleaner fit and finish on the top play surface.
Any of these would be a good choice for a custom pinball machine. You would want to make the decision early on, however, since the Playfield would have to be drilled to accept the specific hardware. Most likely, you will base this on what’s available in your stock or on eBay.
It’s much cheaper to buy a used Bumper unit, and if necessary rebuild with new top-side parts for cosmetic considerations. A used unit that already has the brackets, coil, metal ring assembly and the switch, can be re-built to like-new condition with the following parts:
These can be found at Marco Specialties or Pinball Life:
- Pop bumper cap red star – Stern #13A-12-1
- Pop bumper base 03-6009-A5 #C-115-1
- Pop bumper body 03-9675 #C-114-3
- Ring and rod assembly 60-1705 #A-4754
- Pop bumper skirt – white #03-6035-5
- Lamp socket small bayonet pop bumper #E-120-25
- Spring – compression pop bumper 10A-7 #10-7
And if you decide to start fresh instead of rebuilding, you can find this as an assembly:
- Pop bumper lower bracket assembly #515-6459-04
Here’s what the top-side parts look like assembled:
If your assembly already has a base, you probably will not need the Playfield insert. These parts can then be added to the rest of the sub-assembly, making the installation and future repair that much easier.
- CAD diagram of EV2 version of Bumper, showing Playfield cutout. You can right click here and “save as”, or click through to preview in most browsers. Keep this item as a template in your custom pinball artwork file, then import into Inkscape or other drawing programs.